top of page

Drums

​

HOW TO TURN YOUR ACOUSTIC DRUMS INTO ELECTRONIC DRUMS

EVEN IF YOU DON'T KNOW MUCH ABOUT IT AND ARE NO PRO IN ELECTRONICS

​

Here's how I converted a cheap drum kit (any kit will do) into an electronic kit. Honestly, I never thought I'd be able to do that, so thanks a lot to all those who've put their experiments and expertise online.

Most of the stuff was bought either at Michenaud & Co. (Nantes, France), or www.drum-tec.de (Germany). Thanks to Alex & Michael for their advice and their patience.

NB: I am not saying the conversion was cheap (except for the toms)...

 

EQUIPMENT USED

- 5 mesh heads (from Michenaud & drum-tec). Don't forget to stick some kind of plastic reinforcement where the bass-drum beater hits the head, since felt beaters damage mesh heads (and vice-versa).

- 5 DDRUM replacement triggers (piezo + foam) from Drum-tec + double sided carpet tape (something really strong!)

- 5 female mono jacks (www.e44.fr)

- 5 metal corner braces (any DIY shop)

- VH-11 hi-hat Roland

- 1 dual-zone Smartrigger crash cymbal (Drum-tec)

- 1 triple zone Smartrigger ride cymbal (Drum-tec)

- 1 Roland TD10 sound module (second hand) - any module by Roland will do the trick (but the VH-11 hi-hat is not compatible with all modules).

​

RESULT

The snare drum needs another job with a stereo jack and two piezos, but I haven't done that yet. For the moment I am using a Roland td5-rs trigger on it (Michenaud, with mesh head).

IMG_6315.JPG

INSTALLING THE TRIGGERS

- For each shell, take off the original head,

- unscrew a tension lug (the one closest to where you will fit the jack plug),

- adapt the holes of a metal corner brace so as to install it inside the shell by using the original lug screws,

- solder a mono jack to the piezo (red = tip)

- stick the foam inside the mesh head, dead centre, with double-sided carpet tape.

- drill  a hole near the tension lug where you will fit the jack plug,

- if necessary,  work out the boring inside

- fit the female jack plug

- put the mesh head on the shell, and fix the piezo cables on the corner brace with tape to prevent them from moving around when you're playing,

- repeat the same operation for each shell, and plug !

The rest is a question of finding the right settings on your module.

It's working great for me !

bottom of page